The Hyundai Santa Fe of 2018 to 2024 is one of the few mid-size SUVs a wholesaler can build a screen programme on. It sold in volume across four continents, the factory display sits on a stalk above the dash rather than buried in it, and the vent and climate panel underneath were never part of the radio.
The part is 9269/2269: a 9 or 10.1 inch floating panel on a frame cut for this dash, not a double-DIN cage behind a blanking plate. The factory display comes off, the new frame takes its footprint, and the vent, hazard switch and climate knobs do not move.
Three groups order it. Accessory distributors in the Gulf, South-East Asia and North Africa want the fitment list and the carton count. Audio shops in Europe and Australia ask how long the loom takes. Fleet refurbishers ask whether the steering wheel buttons survive.
Hyundai ran two centre stacks through this car. The earlier one puts a button bank either side of the display: RADIO, MEDIA and SEEK left, HOME, PHONE and SETUP right, a knob at each outer corner. The later one deletes the bank and centres the hazard switch inside a wider vent.
Buyers who read 2018-2024 as a single moulding cause most returns here. One part number covers both, but the frame meets the dash differently: around the bank, or around the vent.
| Console | What you see with the ignition on | What it changes |
|---|---|---|
| Button bank | RADIO, MEDIA, SEEK left; HOME, PHONE, SETUP right; two knobs | Frame follows the bank, deleted with the factory head unit |
| Wide vent | No button bank, wider centre vent, hazard switch centred in it | Frame meets the dash around the vent, not on top of it |
| Either form | Small factory display on a stalk above the dash | Same head unit and harness family |
Three steps, no cutting. Display and stalk out, frame and vehicle-specific harness in, glass where the factory screen was. The wiring is the slow part, not the plastic.
Both panels share the fascia and the loom, so the choice is about the buyer, not the car. The 9 inch leaves a visible border of dash at each side and keeps the factory look; the 10.1 inch fills the aperture edge to edge and demos better on a showroom wall. The carton is sealed once it leaves, so ask first.
The kit is built on several boards. The entry board covers radio, CarPlay and navigation; the higher steps are there for split screen, offline maps and keep-alive apps. The 6+128G board is the one whose About page is pictured below.
| Series | Memory steps | Processor | Order it for |
|---|---|---|---|
| DTBR / DTVR | 2+32G, 4+64G | ARM Cortex-A53, quad-core | Volume accounts, radio and CarPlay |
| DTC / DTE / DTM | 4+32G, 8+128G, 8+256G | UIS7862, 2 x A75 + 6 x A55 at 1.8 GHz | Retail and demo cars, split screen |
| DTVS / DTF | 4+64G, 6+128G | UIS8581A, Cortex-A55 at 1.6 GHz | Fleet and installer accounts |
Published figures for this fitment, plus what the bench unit reports about itself.
| Item | Specification |
|---|---|
| Panel | 9 inch or 10.1 inch touch, QLED, 1280 x 720; 2K build listed separately |
| Operating system | Android 15 |
| Chipset | Unisoc UMS512 on the 6+128G board, UIS7862 and UIS8581A on other series |
| Memory | 2+32G, 4+64G, 6+128G, 8+128G, 8+256G by series |
| Sound processor | ROHM32107 |
| Radio module | TDA7708, FM with RDS and six presets per band |
| Wireless | Bluetooth 5.0 BLE, WiFi, 4G on the higher boards |
| Positioning | GPS, Beidou and AGPS together |
| Phone projection | Wireless CarPlay and wireless Android Auto |
| Options | DVR, DAB, OBD2, TPMS, AHD reverse camera, 360 surround view |
A vehicle-specific harness carries power, speakers and the steering wheel keypad to the new head unit, and the CANBUS adapter keeps the car talking to it. That is why a kit bought on price alone often comes back.
The amplifier is the question we ask before the carton is sealed. A Santa Fe with a factory amplified system needs the harness pinned for it; fit the standard loom and the radio goes silent or plays very quietly, which is miserable to diagnose once the dash is back together.
Two answers settle an order: which console the car has, and whether it left the factory with an amplifier. A photo with the ignition on and the VIN answer both in one reply.
The home screen puts a speedometer dial, the radio widget and a map tile on one page, with the shortcut dock along the bottom. The 360 button only appears when a surround-view kit is wired, so a car without cameras shows a clean dock.
The radio is the screen a driver touches every day: FM with RDS, six presets per band, a tuner that holds a weak signal longer than the factory unit. Settings keep a sleep mode, a reversing input and an About page naming the board.
Spoken commands cover music, radio, navigation and volume in English, Russian, Arabic, Spanish, Portuguese, French, German, Italian, Thai and Indonesian. It takes short commands, not conversation, but a Gulf or CIS buyer reaching for the volume at speed notices it.
Themes download over the network from the unit itself, and the picker ships with a set of skins that swap in a tap. One part number can leave the shop looking like a different product to three resellers, with no second SKU on the shelf.
None of the options changes the frame, so they can be quoted after the fitment is settled. The cable run is the part to decide early: a reversing camera means routing through the tailgate, which is far easier with the dash already open.
| Option | Part | What it changes |
|---|---|---|
| DAB+ antenna | DAB-001 | Digital radio where the market still broadcasts it |
| USB dash camera | DVR-010 | Front recording with ADAS, card in the box |
| OBD2 reader | OBD-001 | Live engine data on the screen |
| TPMS | TPMS-006 | Four tyre sensors on the panel |
| AHD reverse camera | S305 | Tailgate or bracket camera, 1280 x 720 |
| 360 surround view | S360A | Four cameras, bird view on the screen |
The car in the installation photo runs the four-camera set, which is why its dock shows a bird view beside a fisheye feed. That kit is separate hardware: 360 panoramic surround view camera system for Android radios.
Two upgrades sit beside this kit and neither replaces it. The first is a 2K 2000 x 1200 build of the same panel: laminated glass, a quoted 40 percent better display effect in direct sun, same fascia. See the 2K 2000x1200 9 and 10.1 inch screen if your buyers complain about glare.
The second is the 12.3 inch ultra-wide panel, quoted as 12.3 inch smart ultra wide screen for the Hyundai Santa Fe 2018-2024. It covers more of the dash and fills the space the button bank took, the right answer for a buyer who wants the cabin to look new.
Yes, in the factory position. The frame is cut around them rather than over them, so the vent keeps its airflow direction and the hazard switch stays wired to the car.
Switch the ignition on and look at the display. A button bank with RADIO and MEDIA on the left is the early form; a wide vent with the hazard switch in the middle is the later one. Both are covered by 9269/2269.
They are carried by the harness and the CANBUS adapter, so it depends on the trim rather than the screen. Tell us the year and whether the wheel carries the left-hand keypad.
It can, but the cable run through the tailgate is the tedious half. Fit it with the screen while the dash is open; that is the one option we would never leave for later.
No. It uses the same fascia and harness, so settle the console and the screen size first and treat the panel as an upgrade line on the same order.
Say so when you order. The harness has to keep the amplifier alive, and the wrong one gives silence or a very quiet radio, which is awkward to diagnose after the trim is back on.
If you need the price, contact us with the configuration, the quantity and the destination port and we send a quotation the same working day. Published terms are on the WITSON warranty policy page.